It’s finally here! 💛 The wig is ready and so is the tutorial. I hope it’s helpful. The first thing I did was make some templates out of paper. Then I drew a design like this picture and made two copies of the curved piece, and one of the triangular one.
Once I made it, I put them together to create the spike. You can play around with the shape and size to make variations on the hair spikes to fit the feel you want. When I was happy with the templates, I made them out of foam and used a hot glue gun to glue everything together. I made lots of them to use them as the spikes.
When I had all the spikes finished, I painted them yellow and glued them to a wig. The wig should be styled short, but leave a bit of hair there to make more spikes with it later.
When I put all the spikes on the wig, I took hair of other wigs and glued it to the spikes, this part can be a bit tricky because it’s hard not to mess up the hair and it’s easy to burn your fingers with the glue, it happened to me a couple of times 😅 so be very careful.
When I had all the foam pieces covered with hair, I used gel (or spray) to give it a spiky feel and cut the hair that was off to leave it perfect.
I used flat triangles of foam to give the hair that was already on the wig a good shape and glued it to the foam, styled the bangs with gel, and there you go! The wig is finished.
I used flat triangles of foam to give the hair that was already on the wig a good shape and glued it to the foam, styled the bangs with gel,
I used spray paint in the end so the whole wig will have the same color, but make sure you use a respirator mask and do it in a well ventilated place or outside if you can, because it can be toxic and there you go! The wig is finished.
After it dries, put it on and take your Saiyan form… Good luck! 😉